Group 5000
D014/D015/D078/D079 5-196 SM
Local Phone Number
161
Use this SP to set the telephone number of the line where embedded RCG-M is
connected. This number is transmitted to and used by the Call Center to return
calls.
Limit: 24 numbers (numbers only)
Connection Timing Adjustment Incoming
162
When the Call Center calls out to an embedded RCG-M modem, it sends a
repeating ID tone (*#1#). This SP sets the time the line remains open to send
these ID tones after the number of the embedded RCG-M modem is dialed up
and connected.
[0 to 24 / 1 / 1 /step]
The actual amount of time is this setting + 2 sec. For example, if you set "2", the
line will remain open for 4 sec.
Access Point
163
This is the telephone number of the dial-up access point for embedded RCG-M.
If no setting is done for this SP code, then a preset value (determined by the
country selected) is used.
Default: 0
Allowed: Up to 16 numeral characters
Line Connecting
164
This SP sets the connection conditions for the customer. This setting dedicates
the line to embedded RCG-M only, or sets the line for sharing between
embedded RCG-M and a fax unit.
[0 or 1 / 0 / - ]
0: Line shared by embedded RCG-M/Fax
1: Line dedicated to embedded RCG-M only
If this setting is changed, the copier must be cycled off and on.
SP5816-187 determines whether the off-hook button can be used to
interrupt an embedded RCG-M transmission in progress to open the line for
fax transaction.
To Next Page
Loading...
