R&S ZNB Series - Page 1095

Command reference
R&S
®
ZNB/ZNBT
1095User Manual 1173.9163.02 ─ 62
CONTrol<Ch>:SEGMent<Nr>:SEQuence:CLEar:ALL
For segmented sweeps this command deletes the command/switch sequence for the
respective channel and sweep segment (defined using CONTrol<Ch>:
SEGMent<Nr>:RFFE<Bus>:COMMand:DATA and CONTrol<Ch>:SEGMent<Nr>:
GPIO<Port>:VOLTage).
Suffix:
<Ch>
.
Channel number
<Nr> Segment number
Usage: Event
Manual operation: See "Range" on page 559
CONTrol<Ch>:SEGMent<Nr>:SEQuence:COUNt?
For segmented sweeps this command queries the length of the command/switch
sequence defined for a particular channel and sweep segment.
The command/switch sequences are defined using CONTrol<Ch>:SEGMent<Nr>:
RFFE<Bus>:COMMand:DATA and CONTrol<Ch>:SEGMent<Nr>:GPIO<Port>:
VOLTage.
Suffix:
<Ch>
.
Channel number
<Nr> Segment number
Usage: Query only
Manual operation: See "Range" on page 559
CONTrol<Ch>:SEQuence:CLEar:ALL
For unsegmented sweeps this command deletes the command/switch sequence for
the respective channel (defined using CONTrol<Ch>:SEQuence<Nr>:RFFE<Bus>:
COMMand:DATA and CONTrol<Ch>:SEQuence<Nr>:GPIO<Port>:VOLTage).
Suffix:
<Ch>
.
Channel number
Usage: Event
Manual operation: See "Range" on page 559
CONTrol<Ch>:SEQuence:COUNt?
For unsegmented sweeps this command queries the length of the command sequence
defined for a particular channel (using CONTrol<Ch>:SEQuence<Nr>:RFFE<Bus>:
COMMand:DATA).
SCPI command reference