R&S ZNB Series - Page 1117

Command reference
R&S
®
ZNB/ZNBT
1117User Manual 1173.9163.02 ─ 62
<WndTr> ignored
Parameters:
<TraceName> Trace name (string parameter), e.g. 'Trc4'
<Boolean> ON | OFF – display or hide the label of the related trace
Example:
*RST; :DISP:TRAC:LAB:SHOW? 'Trc1'
Reset the analyzer, creating the default trace 'Trc1'. The trace
label is displayed; the query returns 1.
DISP:TRAC:LAB:SHOW 'Trc1', OFF
Hide the label of trace 'Trc1'.
Manual operation: See "Table Area" on page 337
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:SHOW <TraceName>[, <Boolean>]
Displays or hides an existing trace, identified by its trace name <Trace_Name>, or a
group of traces.
Tip: You can open the trace manager to obtain an overview of all channels and traces,
including the traces that are not displayed.
Suffix:
<Wnd>
.
Number of a diagram area. This suffix is ignored; the command
affects traces in all diagram areas.
<WndTr> Trace number. This suffix is ignored; the trace is referenced by
its name.
Parameters:
<TraceName> DALL – all data traces
MALL – all memory traces
<string> – single trace identified by its trace name (string param-
eter), e.g. 'Trc4'.
<Boolean> ON | OFF – display or hide traces.
Example:
*RST; :DISP:TRAC:SHOW? 'Trc1'
Reset the analyzer, creating the default trace 'Trc1'. The trace is
displayed; the query returns 1.
CALC4:PAR:SDEF 'Ch4Tr1', 'S11'
Create channel 4 and a trace named Ch4Tr1 to measure the
input reflection coefficient S
11
.
DISP:WIND2:STAT ON; :DISP:WIND2:TRAC:FEED
'CH4TR1'
Create diagram area no. 2 and display the generated trace in
the diagram area.
DISP:TRAC:SHOW DALL, OFF
Hide both traces in both diagrams.
DISP:TRAC:SHOW? DALL
Query whether all data traces are displayed. The response 0
means that at least one trace is hidden.
Manual operation:
See "Table Area" on page 337
SCPI command reference