R&S ZNB Series - Page 1131

Command reference
R&S
®
ZNB/ZNBT
1131User Manual 1173.9163.02 ─ 62
Parameters:
<RightMargin> Right margin
Range: 0.01 mm to 10000 mm
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:MARG:LEFT 10; RIGHT 10
Set an left and a right margin of 1 cm.
HCOPy:PAGE:MARGin:TOP <UppMargin>
Defines the distance between the top of the page and the top of the printed informa-
tion.
Parameters:
<UppMargin> Upper margin
Range: 0.01 mm to 10000 mm
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:MARG:BOTT 10; TOP 10
Set an upper and a lower margin of 1 cm.
HCOPy:PAGE:ORIentation <Orientation>
Defines the orientation of the printed page. Switching between LANDscape and
PORTrait rotates the hardcopy result by 90 degrees. No other settings are changed.
Parameters:
<Orientation> LANDscape | PORTrait
LANDscape - long edge of the paper is the top of the page.
PORTrait - short edge of the paper is the top of the page.
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:ORI LAND; :HCOP
Select landscape page orientation and start printing.
HCOPy:PAGE:WINDow <PrintDiagram>
Defines how the diagrams shall be printed (using HCOPy[:IMMediate].
Parameters:
<PrintDiagram> ALL | SINGle | ACTive | HARDcopy | NONE
ALL - all diagrams are printed on one page.
SINGle - one diagram per page.
ACTive - print only active diagram.
HARDcopy - print a screenshot of the diagram area, preserving
layout and colors ("real screenshot")
NONE - print no diagram at all.
*RST: n/a (*RST does not affect the printer configuration)
SCPI command reference