To Next Page

To Previous Page

Command reference

R&S

ZNB/ZNBT

1147User Manual 1173.9163.02 ─ 62

Example:

MMEM:LOAD:CKIT:SDAT 'N 50 Ohm','Default

Kit',MOPEN,'Test data','test.s1p',1

Load the file Test.s1p from the current directory in order to

define the properties of an Open (m) standard in the cal kit

named "Default Kit" for the N 50 Ω connector type. Assign the

label "Test data" and specify that the standard data is valid for

port no. 1 only.

Usage: Setting only

Manual operation: See "Read .s1p File... / Read .s2p File..." on page 518

Connector and cal kit naming conventions:

Connector and calibration kit names must be entered as string parameters. The strings

contain the connector and cal kit names used in the Calibration Kits dialog; a Ω

in the name must be replaced by 'Ohm', e.g.:

–'NewKit1' denotes the user-defined calibration kit "NewKit1".

–'N 50 Ohm Ideal Kit' denotes the "N 50 Ω Ideal Kit".

–'ZV-Z21 typical' denotes the cal kit "ZV-Z21 typical".

MMEMory:LOAD:CKIT:SDATa:WLABel <ConnectorType>, <CalKitName>,

<KitLabel>, <StandardType>, <StandardLabel>, <TouchstoneFile>[,

<FirstPort>[, <SecondPort>]]

Loads characterization data from the given Touchstone file; similar to existing com-

mand MMEMory:LOAD:CKIT:SDATa but supports cal kit addressing by label.

Setting parameters:

<ConnectorType> String parameter containing the name of the connector type.

<CalKitName> String parameter containing the name of a calibration kit availa-

ble on the analyzer.

<KitLabel> String parameter containing the label of a calibration kit available

on the analyzer. An empty string means that no label is defined.

Standard types; for a description refer to table Standard types

and their parameters.

<StandardLabel> String parameter addressing a particular calibration standard by

its label. An empty string means that no label is defined.

SCPI command reference

R&S ZNB Series User Manual

Questions and Answers: