R&S ZNB Series - Page 1157

Command reference
R&S
®
ZNB/ZNBT
1157User Manual 1173.9163.02 ─ 62
Example: Assume that the current recall set contains two channels num-
bered 1 and 2, respectively, and that sweep segments have
been defined for channel no. 1.
MMEM:STOR:SEGM 1, 'C:\Users\Public\Documents\
Rohde-Schwarz\Vna\SweepSegments\Seg_Ch1.SegList'
Store the sweep segment definition of channel 1 to a sweep
segment file.
MMEM:LOAD:SEGM 2, 'C:\Users\Public\Documents\
Rohde-Schwarz\Vna\SweepSegments\Seg_Ch1.SegList'
Load the previously created sweep segment file and use the
sweep segments for channel 2.
Usage: Setting only
Manual operation: See "Import.../ Export..." on page 434
MMEMory:LOAD:STATe
<Compatibility>, <RecallSetFile>
Loads configuration data from a specified recall set file (*.znx|*.znxml) and sets
the analyzer to the corresponding instrument state.
Setting parameters:
<Compatibility> 1 (this value is used for compatibility with the SCPI standard but
is ignored).
<RecallSetFile> String parameter to specify the absolute or relative path of the
recall set file to be loaded. Relative paths are evaluated relative
to the current directory (see MMEMory:CDIRectory).
Example:
MMEM:STOR:STAT 1,'C:\Users\Public\Documents\
Rohde-Schwarz\Vna\RecallSets\Set_0413.znx'
Store the current setup configuration in the file Set_0413.znx
in the default directory for recall set files.
MMEM:LOAD:STAT 1,'C:\Users\Public\Documents\
Rohde-Schwarz\Vna\RecallSets\Set_0413.znx'
Load the settings stored in Set_0413.znx.
Usage: Setting only
Manual operation: See "Open Recall..." on page 670
MMEMory:LOAD:TRACe <DestinationTraceName>, <TraceFile>[,
<SParamOrTraceName>]
Loads trace data from a specified trace file and assigns it to a trace with a specified
name. Traces are created using the CALCulate<Ch>:PARameter:SDEFine com-
mand.
SCPI command reference