Annexes
R&S
®
ZNB/ZNBT
1561User Manual 1173.9163.02 ─ 62
ENA Emulation Command R&S ZNB/ZNBT Default Parser Command
SENSe{1...4}:FREQuency:SPAN <numeric>
[SENSe<Ch>:]FREQuency:SPAN
SENSe{1...4}:FREQuency:STARt <numeric>
[SENSe<Ch>:]FREQuency:STARt
SENSe{1...4}:FREQuency:STOP <numeric>
[SENSe<Ch>:]FREQuency:STOP
SENSe{1...4}:ROSCillator:SOURce?
[SENSe<Ch>:]ROSCillator[:SOURce]
SENSe{1...4}:SEGMent:SWEep:POINts?
[SENSe<Ch>:]SEGMent<Seg>:SWEep:POINts
SENSe{1...4}:SEGMent:SWEep:TIME?
[SENSe<Ch>:]SEGMent<Seg>:SWEep:TIME
SENSe{1...4}:SEGMent:DATA 5,<mode>,
<ifbw>, <pow>, <del>, <time>, <segm>,
<star 1>, <stop 1>, <nop 1>, <ifbw 1>,
<pow 1>, <del 1>, <time 1>,...,
SENSe{1...4}:SWEep:DELay <numeric>
[SENSe<Ch>:]SWEep:DWELl
SENSe{1...4}:SWEep:MOD CONTinuous |
HOLD | SINGle
SENSe{1...4}:SWEep:MODE CONTinuous |
HOLD | SINGle
SENSe{1...4}:SWEep:POINts <numeric>
[SENSe<Ch>:]SWEep:POINts
SENSe{1...4}:SWEep:TIME[:DATA]
<numeric>
[SENSe<Ch>:]SWEep:TIME
SENSe{1...4}:SWEep:TIME:AUTO {ON | OFF
| 1 | 0}
[SENSe<Ch>:]SWEep:TIME:AUTO
SENSe{1...4}:SWEep:TYPE {LINear |
SEGMent}
[SENSe<Ch>:]SWEep:TYPE
SERVice:CHANnel:COUNt?
n.a. (no limit)
SERVice:CHANnel:TRACe:COUNt?
n.a. (no limit)
SOURce{1...4}:POWer[:LEVel][:
IMMediate][:AMPLitude] <numeric>
SOURce<Ch>:POWer<PhyPt>[:LEVel][:
IMMediate][:AMPLitude]
SOURce<ch>:POWer<pt>:CORRection[:
STATe] {ON | OFF | 1 | 0}
SOURce<Ch>:POWer<PhyPt>:CORRection:
STATe
SOURce<ch>:POWer<pt>:CORRection:
COLLect:AVERage[:COUNt] <numeric>
SOURce:POWer:CORRection:COLLect:
AVERage[:COUNt]
SOURce:POWer<pt>:CORRection:COLLect:
AVERage:NTOLerance <numeric>
SOURce:POWer:CORRection:COLLect:
AVERage:NTOLerance
SOURce<ch>:POWer<pt>:CORRection:
COLLect:SAVE [<RREC>]
n.a. (instrument automatically applies calibration
after it is complete)
SOURce{1..4}:POWer:PORT:COUPle {ON |
1}
STATus:OPERation:CONDition?
STATus:QUEStionable:CONDition?
STATus:OPERation:ENABle <numeric>
STATus:QUEStionable:ENABle
STATus:OPERation[:EVENt]?
STATus:QUEStionable[:EVENt]?
ENA emulation commands
To Next Page
Loading...
Need help?
General
