GUI reference
R&S
®
ZNB/ZNBT
340User Manual 1173.9163.02 ─ 62
Data to <Destination>
Stores the current state of the active data trace to the Destination memory trace. No
trace functions are applied to the stored trace.
Tips:
●
Use Data & Func to <Destination> to apply trace functions to the stored trace.
●
You can also create memory traces using the Import Complex Data dialog.
●
It is not possible to store Hold traces to memory.
●
For the relation between a data trace and its associated memory traces, see "Cou-
pling of data and memory traces" on page 339.
Remote command:
CALCulate<Chn>:MATH:MEMorize
TRACe:COPY
Data & Func to <Destination>
Stores the current state of the active data trace – including trace functions – to the
Destination memory trace.
Trace functions
The trace functions comprise the following mathematical operations:
●
Active trace math on unformatted and formatted traces, as configured in the Chap-
ter 5.5.4, "Math tab", on page 342.
●
A shift of the data trace (see "Shift Trace" on page 363).
Data to <Destination> stores the raw trace without the trace functions, "Data & Func to
<Destination>" stores the trace after it has been transformed using the trace functions.
For the relation between a data trace and its associated memory traces, see "Coupling
of data and memory traces" on page 339.
Remote command:
CALCulate<Chn>:MATH:MEMorize
TRACe:COPY:MATH
Destination
Selects the destination for the Data to <Destination> and Data & Func to <Destination>
operations.
The destination can be one of the following:
●
An existing memory trace of the active data trace.
The existing memory trace is overwritten.
●
"New Trace"
The data are copied to a new memory trace, associated to the current data trace.
Remote command:
n/a
Show <Active Data Trace>
Shows or hides the active data trace in the diagram.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:SHOW
Trace Config softtool
To Next Page
Loading...
Need help?
General
