R&S ZNB Series - Page 760

GUI reference
R&S
®
ZNB/ZNBT
760User Manual 1173.9163.02 ─ 62
Remote command:
CALCulate:MARKer:FUNCtion:BWIDth:GMCenter
Error Dump Type
Determines the level of detail ("Minimal", "Normal", "Large", "Full") and hence the size
of the dump files that are created if a firmware exception occurs. "None" disables dump
file creation.
The latest 5 exception dumps can be retrieved using the "Save Report" function of the
"Info" dialog (see "Create R&S Support Information" on page 767).
For further information, see Chapter 9, "Error messages and troubleshooting",
on page 1528.
Remote command:
DIAGnostic:DUMP:SIZE
Touchstone Export Options
Configures whitespace insertion during legacy Version 1.1 (ZNx) Touchstone file
export.
The default export format is explained in Chapter 4.4.2.1, "Touchstone files",
on page 152:
●
logical columns are vertically aligned using spaces
●
positive and negative numbers are vertically aligned by prefixing positive numbers
with blanks
●
the frequencies are horizontally separated from the corresponding S matrices
using leading spaces
●
the content parts (header, S matrices for different frequencies) are separated by
blank lines
Use TAB (instead of blanks) ← Touchstone Export Options
If checked, columns are separated by tabs rather than spaces.
Remote command:
MMEMory:STORe:TRACe:OPTion:TABS
Trim Leading Whitespace ← Touchstone Export Options
If checked, whitespace at the beginning of each line is removed.
Remote command:
MMEMory:STORe:TRACe:OPTion:TRIM
Positive Number Prefix ← Touchstone Export Options
Positive numbers can either be prefixed by blanks, by plus signs or not at all.
Remote command:
MMEMory:STORe:TRACe:OPTion:PLUS
Skip Separator Lines ← Touchstone Export Options
If checked, the content parts are no longer separated by blank lines.
Remote command:
MMEMory:STORe:TRACe:OPTion:SSEParator
Setup softtool