R&S ZNB Series - Page 892

Command reference
R&S
®
ZNB/ZNBT
892User Manual 1173.9163.02 ─ 62
BALanced
Balanced; for balanced lead-ins/outs
COUPled
Coupled ports; for lead-ins/outs with more than two logical ports
UNCoupled
Coupled ports; for lead-ins/outs with more than two physical
ports
Options: R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
Manual operation: See "Left: Model A / Right: Model A|B" on page 656
CALCulate:FMODel:DEASsistant:IMPCorrect <Boolean>
Parameters:
<Boolean>
Manual operation: See "Measure / Apply section" on page 660
CALCulate:FMODel:DEASsistant:PRESet
Resets the DUT and fixture settings of the deembedding assistant to their respective
defaults.
Note that a *RST does not affect these settings.
Usage:
Event
Options: R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
Manual operation: See "DUT" on page 655
CALCulate:FMODel:DEASsistant:RUN
Runs the selected demmbedding (CALCulate:FMODel:DEASsistant:TOOL) tool
and applies the calculated fixture deembedding to the ports selected using
CALCulate:FMODel:DEASsistant:DUT:PORT.
Usage:
Event
Options: R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
Manual operation: See "Measure / Apply section" on page 660
CALCulate:FMODel:DEASsistant:SAMCoupon <Boolean>
For the deembedding assistant, this command defines whether only the left coupon
model is measured or loaded from file.
SCPI command reference