To Next Page

To Previous Page

Command reference

R&S

ZNB/ZNBT

904User Manual 1173.9163.02 ─ 62

CALCulate:FMODel:EZD<Ph_pt>:COUPon[:STATe] <Boolean>

For a fixture modeling with the EZD tool, this command allows to specify the ports to

which the test coupon is connected.

This has to be defined before measuring the test coupon (using CALCulate:FMODel:

EZD:COUPon:MEASure).

Suffix:

<Ph_pt>

Physical port number

Parameters:

<Boolean> ON (1)

if the test coupon is connected to port <Ph_pt>

OFF (0)

otherwise

Options: R&S ZNB/ZNBT-K210

Manual operation: See "Active" on page 631

CALCulate:FMODel:EZD:DCEXtrapolat <Boolean>

Defines whether the Touchstone de-embedding file generated by the EZD tool contains

data for DC.

Parameters:

<Boolean> ON (1)

The EZD tool adds (extrapolated) S-parameter data for f = 0.

OFF (0)

The frequencies only reach down to the start frequency of the

instrument sweep.

Options: R&S ZNB/ZNBT-K210

Manual operation: See "DC Extrapolation" on page 640

CALCulate:FMODel:EZD:DUT:MEASure

For a fixture modeling with the EZD tool, this command allows to measure "DUT + Test

Fixture" at the active ports (see CALCulate:FMODel:EZD<Ph_pt>:DUT[:STATe])

Usage:

Event

Options: R&S ZNB/ZNBT-K210

Manual operation: See "Measure" on page 632

CALCulate:FMODel:EZD:DUT:MEASure:FILename <String>

For a fixture modeling with the EZD tool, this command loads the "DUT + Test Fixture"

properties from a Touchstone file.

SCPI command reference

R&S ZNB Series User Manual

Questions and Answers: