Command reference
R&S
®
ZNB/ZNBT
978User Manual 1173.9163.02 ─ 62
Example:
SWE:TYPE POW
Select a power sweep.
CALC:RIPP:CONT:DOM PLIN
Delete all existing ripple limit ranges and select level units for the
domain of the active trace.
CALC:RIPP:DATA 1, -10, -5, 3
Define and enable a ripple limit range in the stimulus range
between -10 dBm and -5 dBm, assigning a ripple limit of 3 dB.
Usage: Setting only
Manual operation: See "Add / Insert / Delete / Delete All / Align All" on page 385
CALCulate<Chn>:RIPPle:DATA <RippleLimRange>...
Adds and enables/disables an arbitrary number of ripple limit ranges, assigning the
stimulus values and the ripple limits. See Chapter 4.4.1.2, "Rules for ripple test defini-
tion", on page 147.
Note: This command does not overwrite existing ripple limit ranges. The defined
ranges are appended to the range list as new ranges. Use the
CALCulate<Chn>:RIPPle:SEGMent<Seg>... commands to change existing ripple
limits.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<RippleLimRange> Parameter list in the format <Type>, <StartStimulus>, <StopSti-
mulus>, <RippleLimit>[, {<Type>, <StartStimulus>, <StopStimu-
lus>, <RippleLimit>}], where:
<Type> – Boolean identifier for the ripple limit range type. 1 for
ripple limit range on (with limit check). 0 for ripple limit range off:
The range is defined, but no limit check result displayed. The
result is still available via CALCulate<Chn>:RIPPle:
SEGMent<Seg>:RESult?.
<StartStimulus>/<StopStimulus>– stimulus values (unitless) con-
fining the ripple limit range
<RippleLimit> – ripple limit (unitless) in the stimulus range
between <StartStimulus> and <StopStimulus>
The unit of a stimulus value is adjusted to the sweep type of the
active channel ([SENSe<Ch>:]SWEep:TYPE), the unit of a rip-
ple limit is adjusted to the format of the active trace
(CALCulate<Chn>:FORMat).
Range:
Virtually no restriction for ripple limit ranges.
*RST: n/a (no ripple limit line defined after a reset)
SCPI command reference
To Next Page
Loading...
