R&S ZNB Series - Page 1169

Command reference
R&S
®
ZNB/ZNBT
1169User Manual 1173.9163.02 ─ 62
Setting parameters:
<TraceName> Name of the related eye diagram
<TraceFile> String parameter containing the path and file name of the eye
mask file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
Usage: Setting only
Options: R&S ZNB/ZNBT-K20
Manual operation: See "Save / Load Mask Configuration" on page 707
MMEMory:STORe:EYE:MASK:RESults
<TraceName>, <TraceFile>
Saves the detailed results of the mask test in the related eye diagram to an ASCII file
(see CALCulate<Chn>:EYE:MASK:DATA? on page 871).
This command will raise an execution error if CALCulate<Chn>:EYE:MASK:STATe is
OFF.
Setting parameters:
<TraceName> The name of the eye diagram whose mask test results shall be
exported
<TraceFile> Mandatory string parameter containing the path and file name of
the file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
Usage: Setting only
Options: R&S ZNB/ZNBT-K20
Manual operation: See "Export Test Results" on page 704
MMEMory:STORe:EYE:MEASurements <TraceName>, <TraceFile>[,
<DecSeparator>[, <FieldSeparator>]]
Allows to export eye diagram results to an ASCII file (csv), with the possibility to spec-
ify a decimal separator (comma or point) and a field separator (semicolon, comma, tab
or space).
See also CALCulate<Chn>:EYE:MEASurement:DATA? on page 877.
Note that the decimal separator and field separator must be different: if both are set to
comma, actually a semicolon will be used as field separator.
Setting parameters:
<TraceName> The name of the eye diagram whose results shall be exported
<TraceFile> Mandatory string parameter containing the path and file name of
the file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
SCPI command reference