R&S ZNB Series User Manual

GUI reference
R&S
®
ZNB/ZNBT
637User Manual 1173.9163.02 ─ 62
●
"Odd on left" (default): 1, 3, 5, etc. are on the left and ports 2, 4, 6, etc. are on the
right.
●
"All on left": All ports are on the left
Note: Ports on the left/right are assumed to be coupled (if Trace Coupling is not set to
"None". A port on the left side is not considered to be coupled to a port on the right
side.
Remote command:
CALCulate:FMODel:ISD:PORT:ORDer
DUT Type ← DUT With Fixture
Select "Passive"/"Active" if the DUT is passive/active.
Default is "Passive".
Remote command:
CALCulate:FMODel:ISD:DUT:TYPE
Ports to Skip ← DUT With Fixture
Tells the ISD tool which ports (in the measured "DUT + Test Fixture" file) to skip when
the tool is run.
●
"None" (default): do not skip any ports
●
"Ports on left": Skip the ports on the left (according to the selected Port Sequence)
●
"Ports on right": Skip the ports on the right (according to the selected port
sequence)
●
"Manually set ports": use Ports to Skip (manual) to define the ports to be skipped
Remote command:
CALCulate:FMODel:ISD:PORT:SKIP:NONE
CALCulate:FMODel:ISD:PORT:SKIP:LEFT
CALCulate:FMODel:ISD:PORT:SKIP:RIGHt
Ports to Skip (manual) ← DUT With Fixture
If Ports to Skip is set to "Manually set ports", this text field allows you to define the
ports to be skipped. Enter the port numbers, separated by blanks (e.g. '1 3 4').
Remote command:
CALCulate:FMODel:ISD:PORT:SKIP
Calculations
Some additional parameters that define how the ISD tool calculates its output.
Enforce Passitivity ← Calculations
If checked (default), the ISD tool enforces passivity and reciprocity for the test coupons
and the test fixture.
Remote command:
CALCulate:FMODel:ISD:PASSivity
Trace Coupling ← Calculations
Tells the ISD tool about coupling among lead-in traces
●
"None": No coupling.
The ISD tool optimizes odd- and single-ended insertion losses.
Offset Embed softtool

R&S ZNB Series Specifications

General

Brand	R&S
Model	ZNB Series
Category	Measuring Instruments
Language	English