R&S ZNB Series - Page 915

Command reference
R&S
®
ZNB/ZNBT
915User Manual 1173.9163.02 ─ 62
CALCulate:FMODel:ISD:PRESet
Restores the global default settings of the ISD tool.
Usage: Event
Manual operation: See "Reset to Default" on page 629
CALCulate:FMODel:ISD:RUN:RUN
Runs the ISD tool.
Before executing this command, make sure that
●
the test coupon measurement (using CALCulate:FMODel:ISD:COUPon:
MEASure:OPEN and CALCulate:FMODel:ISD:COUPon:MEASure:SHORt for
1xOpen+1xShort, CALCulate:FMODel:ISD:COUPon:MEASure otherwise) fin-
ished successfully, or the test coupon data were successfully loaded from file
(using CALCulate:FMODel:ISD:COUPon:MEASure:FILename
●
the measurement of DUT + test fixture (using CALCulate:FMODel:ISD:DUT:
MEASure) finished successfully
The resulting Touchstone files are written to C:\Users\Public\Documents\Rohde-
Schwarz\Vna\Embedding. If result files with the same name already exist, they will be
overwritten.
Example:
See Chapter 8.2.8, "Fixture modeling", on page 1527
Usage: Event
Manual operation: See "Run <Fixture Modeling Tool>" on page 633
CALCulate:FMODel:ISD<Pt>:RUN[:STATe] <Boolean>
For a fixture modeling with the ISD tool, this command allows to specify the ports to
which the deembedding files shall be assigned after the tool has run.
Suffix:
<Pt>
.
Physical port number for single-ended deembedding, logical port
number for balanced deembedding.
Parameters:
<Boolean> 1 (ON) if a deembedding file shall be assinged to port <Pt>, 0
(OFF) otherwise
Example: See Chapter 8.2.8, "Fixture modeling", on page 1527
Manual operation: See "Apply" on page 634
CALCulate:FMODel:ISD:SCALe:ATTenuation <AttenLeadInScaling>
Scales the test coupon’s attenuation (dB).
Sets/gets the atten_scale 1 batch mode parameter of the ISD tool
SCPI command reference