NetApp CN1610 - Page 120

Chapter 3: Management Commands 117
The following shows example CLI display output for the command.
(CN1610) #show radius servers
Cur Host Address Server Name Port
Type
rent
---- ------------------------ --------------------------------- ---
-- ----------
* 192.168.37.200 Network1_RADIUS_Server 1813
Primary
192.168.37.201 Network2_RADIUS_Server 1813
Secondary
192.168.37.202 Network3_RADIUS_Server 1813
Primary
192.168.37.203 Network4_RADIUS_Server 1813
Secondary
(CN1610) #show radius servers name
Current Host Address Server Name Type
------------------------ --------------------------------- -------
---192.168.37.200 Network1_RADIUS_Server
Secondary
192.168.37.201 Network2_RADIUS_Server Primary
192.168.37.202 Network3_RADIUS_Server Secondary
192.168.37.203 Network4_RADIUS_Server Primary
(CN1610) #show radius servers name Default_RADIUS_Server
Server Name............................ Default_RADIUS_Server
Host Address........................... 192.168.37.58
Secret Configured...................... No
Message Authenticator ................. Enable
Number of Retransmits.................. 4
Time Duration.......................... 10
RADIUS Attribute 4
Mode
A global parameter to indicate whether the NAS-IP-
Address attribute has been enabled to use in
RADIUS requests.
RADIUS Attribute 4
Value
A global parameter that specifies the IP address to
be used in NAS-IP-Address attribute used in
RADIUS requests.
Field Description