NetApp CN1610 - Page 19

16 Command Modes
Interface Config
(CN1610) (Interface
slot/port)#
(CN1610) (Interface
slot/port
(startrange)-
slot/port(endrange)
#
Manages the operation
of an interface.
Use this mode to set up
a physical port for a
specific logical
connection operation.
You can also use this
mode to manage the
operation of a range of
interfaces. For example,
the prompt may display
as follows:
(CN1610) (Interface
0/1-0/4) #
Line Console
(CN1610) (config-
line)#
Contains commands to
configure outbound
Telnet settings and
console interface
settings, as well as to
configure console
login/enable
authentication.
Line SSH
(CN1610) (config-
ssh)#
Contains commands to
configure SSH
login/enable
authentication.
Line Telnet
(CN1610) (config-
telnet)#
Contains commands to
configure Telnet
login/enable
authentication.
AAA IAS User Config
(CN1610) (Config-
IAS-User)#
Allows password
configuration for a user
in the IAS database.
Command Mode Prompt Mode Description