282 sFlow Commands
The following shows example CLI display output for the show sflow receivers
command.
(CN1610) #show sflow receivers 1
Receiver Index................................. 1
Owner String................................... tulasi
Time out....................................... 0
IP Address:.................................... 0.0.0.0
Address Type................................... 1
Port........................................... 6343
Datagram Version............................... 5
Maximum Datagram Size.......................... 1400
The following examples show CLI display output for the command when a
receiver is configured as a non-timeout entry.
(CN1610) #show sflow receivers
Rcvr Owner Timeout Max Dgram Port IP
Address
Indx String Size
---- -------------------------------- ---------- --------- ----- --
-------------
Time Out The time (in seconds) remaining before the receiver
is released and stops sending samples to sFlow
receiver. The no timeout value of this parameter
means that the sFlow receiver is configured as a non-
timeout entry.
Max Datagram Size The maximum number of bytes that can be sent in a
single sFlow datagram.
Port The destination Layer4 UDP port for sFlow
datagrams.
IP Address The sFlow receiver IP address.
Address Type The sFlow receiver IP address type. For an IPv4
address, the value is 1 and for an IPv6 address, the
value is 2.
Datagram Version The sFlow protocol version to be used while sending
samples to sFlow receiver.
Parameter Description
To Next Page
Loading...
