Chapter 4: Utility Commands 305
The following shows example CLI display output for the command.
(CN1610) #show rmon hcalarms
Index OID Owner
----------------------------------------------
1 alarmInterval.1 MibBrowser
2 alarmInterval.1 MibBrowser
(CN1610) #show rmon hcalarm 1
Alarm 1
----------
OID: alarmInterval.1
Last Sample Value: 1
Interval: 1
Sample Type: absolute
Startup Alarm: rising-falling
Rising Threshold High: 0
Rising Threshold Low: 1
Rising Threshold Status: Positive
Falling Threshold High: 0
Falling Threshold Low: 1
Falling Threshold Status: Positive
Rising Event: 1
Falling Event: 2
Startup Alarm: Rising-Falling
Owner: MibBrowser
High Capacity Alarm
Failed Attempts
The number of times the associated
hcAlarmVariable instance was polled on behalf of
thie hcAlarmEntry (while in the active state) and the
value was not available. This object is a 32-bit
counter value that is read-only.
High Capacity Alarm
Owner
The owner string associated with the alarm entry.
The default is monitorHCAlarm.
High Capacity Alarm
Storage Type
The type of non-volatile storage configured for this
entry. This object is read-only. The default is
volatile.
Parameter Description
To Next Page
Loading...
