NetApp CN1610 - Page 348

Chapter 5: Switching Commands 345
Edge Port...................................... FALSE
Edge Port Status............................... FALSE
Point to Point MAC Status...................... TRUE
CST Regional Root..............................
80:00:00:10:18:48:FC:07
CST Internal Root Path Cost.................... 0
Loop Inconsistent State........................ FALSE
Transitions Into Loop Inconsistent State....... 0
Transitions Out Of Loop Inconsistent State..... 0
The following shows example CLI display output for the command using a LAG
interface number.
(CN1610) >show spanning-tree mst port detailed 0 lag 1
Port Identifier................................ 60:42
Port Priority.................................. 96
Port Forwarding State.......................... Disabled
Port Role...................................... Disabled
Auto-calculate Port Path Cost.................. Enabled
Port Path Cost................................. 0
Auto-Calculate External Port Path Cost......... Enabled
External Port Path Cost........................ 0
Designated Root................................
80:00:00:10:18:48:FC:07
Root Path Cost................................. 0
Designated Bridge..............................
80:00:00:10:18:48:FC:07
Designated Port Identifier..................... 00:00
Topology Change Acknowledge.................... FALSE
Hello Time..................................... 2
Edge Port...................................... FALSE
Edge Port Status............................... FALSE
Point to Point MAC Status...................... TRUE
CST Regional Root..............................
80:00:00:10:18:48:FC:07
CST Internal Root Path Cost.................... 0
Loop Inconsistent State........................ FALSE
Transitions Into Loop Inconsistent State....... 0
Transitions Out Of Loop Inconsistent State..... 0
--More-- or (q)uit
(CN1610) >