372 Double VLAN Commands
The following shows examples of the CLI display output for the commands.
(CN1610) #show dvlan-tunnel
Primary TPID................................... 0x8100
Secondary TPIDs Configured.....................
Interfaces Enabled for DVLAN Tunneling......... None
(CN1610)#show dvlan-tunnel interface 0/1
Interface Mode EtherType
--------- ------- ------------
0/1 Disable 0x88a8
Term Definition
Interface slot/port
LAG Instead of slot/port
, lag lag-intf-num can be
used as an alternate way to specify the LAG
interface. lag lag-intf-num can also be used to
specify the LAG interface where lag-intf-num is the
LAG port number.
Mode The administrative mode through which Double
VLAN Tunneling can be enabled or disabled. The
default value for this field is disabled.
EtherType A 2-byte hex EtherType to be used as the first 16 bits
of the DVLAN tunnel. There are three different
EtherType tags. The first is 802.1Q, which
represents the commonly used value of 0x8100. The
second is vMAN, which represents the commonly
used value of 0x88A8. If EtherType is not one of
these two values, then it is a custom tunnel value,
representing any value in the range of 1 to 65535.
To Next Page
Loading...
