NetApp CN1610 - Page 417

414 Port-Based Network Access Control Commands
The following example displays the authentication interface information for all
interfaces.
(CN1610) #show authentication interface all
Interface...................................... 1/0/1
Authentication Restart timer................... 300
Configured method order........................ dot1x mab captive-
portal
Enabled method order........................... dot1x mab undefined
Configured method priority..................... undefined undefined
undefined
Enabled method priority........................ undefined undefined
undefined
Number of authenticated clients................ 0
Interface...................................... 1/0/2
Authentication Restart timer................... 300
Configured method order........................ dot1x mab captive-
portal
Enabled method order........................... dot1x mab undefined
Configured method
order
The order of authentication methods used on a port.
Enabled method order The order of authentication methods used on a port.
Configured method
priority
The priority for the authentication methods used on
a port.
Enabled method
priority
The priority for the authentication methods used on
a port.
Number of
authenticated clients
The number of authenticated clients.
Logical Interface The logical interface
Client MAC addr The MAC address for the client.
Authenticated Method The current authentication method.
Auth State If the authentication was successful.
Auth Status The current authentication status.
Term Definition