NetApp CN1610 - Page 426

Chapter 5: Switching Commands 423
Port........................................... 1/0/1
Protocol Version............................... 1
PAE Capabilities............................... Authenticator
Control Mode................................... auto
Authenticator PAE State........................ Initialize
Backend Authentication State................... Initialize
Quiet Period (secs)............................ 60
Transmit Period (secs)......................... 30
Guest VLAN ID.................................. 0
Guest VLAN Period (secs)....................... 90
Supplicant Timeout (secs)...................... 30
Server Timeout (secs).......................... 30
Maximum Requests............................... 2
Configured MAB Mode............................ Enabled
Operational MAB Mode........................... Disabled
VLAN Id........................................ 0
VLAN Assigned Reason........................... Not Assigned
Reauthentication Period (secs)................. 3600
Reauthentication Enabled....................... FALSE
Key Transmission Enabled....................... FALSE
EAPOL flood Mode Enabled....................... FALSE
Control Direction.............................. both
Maximum Users.................................. 16
Unauthenticated VLAN ID........................ 0
Session Timeout................................ 0
Session Termination Action..................... Default
For each client authenticated on the port, the show dot1x detail slot/port
command will display the following MAC-based dot1x parameters if the port-
control mode for that specific port is MAC-based.
Term Definition
Supplicant MAC-
Address
The MAC-address of the supplicant.
Authenticator PAE
State
Current state of the authenticator PAE state machine.
Possible values are Initialize, Disconnected,
Connecting, Authenticating, Authenticated,
Aborting, Held, ForceAuthorized, and
ForceUnauthorized.
Backend
Authentication State
Current state of the backend authentication state
machine. Possible values are Request, Response,
Success, Fail, Timeout, Idle, and Initialize.