538 MLD Snooping Querier Commands
When you specify a value for vlanid, the following information appears.
Field Description
Admin Mode Indicates whether or not MLD Snooping Querier is
active on the switch.
Admin Version Indicates the version of MLD that will be used while
sending out the queries. This is defaulted to MLD v1
and it cannot be changed.
Querier Address Shows the IP address which will be used in the IPv6
header while sending out MLD queries. It can be
configured using the appropriate command.
Query Interval Shows the amount of time in seconds that a
Snooping Querier waits before sending out the
periodic general query.
Querier Timeout Displays the amount of time to wait in the Non-
Querier operational state before moving to a Querier
state.
Field Description
VLAN Admin Mode Indicates whether MLD Snooping Querier is active
on the VLAN.
VLAN Operational
State
Indicates whether MLD Snooping Querier is in
“
Querier” or “Non-Querier” state. When the
switch is in
Querier state, it will send out periodic
general queries. When in
Non-Querier state, it will
wait for moving to
Querier state and does not send
out any queries.
VLAN Operational
Max Response Time
Indicates the time to wait before removing a Leave
from a host upon receiving a Leave request. This
value is calculated dynamically from the Queries
received from the network. If the Snooping Switch is
in Querier state, then it is equal to the configured
value.
To Next Page
Loading...
