Chapter 7: Quality of Service Commands 681
destination-ipv6-
prefix/prefix-
length
|
any
|
host destination-
ipv6-address
Specifies a destination IPv6 source address and
prefix length to match for the IPv6 ACL rule.
Specifying any implies specifying “::/0 “
Specifying
host destination-ipv6-address implies
matching the specified IPv6 address.
This
destination-ipv6-address argument must be
in the form documented in RFC 2373 where the
address is specified in hexadecimal using 16-bit
values between colons.
[dscp
dscp
]
Specifies the dscp value to match for for the IPv6
rule.
flag [+fin | -fin]
[+syn | -syn]
[+rst | -rst]
[+psh | -psh]
[+ack | -ack]
[+urg | -urg]
[established]
Specifies that the IPv6 ACL rule matches on the tcp
flags.
When +<tcpflagname> is specified, a match occurs
if specified <tcpflagname> flag is set in the TCP
header.
When “-<tcpflagname>” is specified, a match
occurs if specified <tcpflagname> flag is *NOT* set
in the TCP header.
When established is specified, a match occurs if
specified either RST or ACK bits are set in the TCP
header.
Two rules are installed in hardware to when
“established” option is specified.
This option is visible only if protocol is “tcp”.
Parameter Description
To Next Page
Loading...
