R&S ZNB Series - Page 946

Command reference
R&S
®
ZNB/ZNBT
946User Manual 1173.9163.02 ─ 62
CALCulate<Chn>:MARKer<Mk>:DELTa[:STATe] <Boolean>
Switches the delta mode for marker <Mk> on trace no. <Chn> on or off. The marker
must be created before using CALCulate<Chn>:MARKer<Mk>[:STATe] ON. If the
active trace contains no reference marker, the command also creates a reference
marker.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number.
Parameters:
<Boolean> ON | OFF - Enables or disables the delta mode.
*RST: OFF
Example: Suppose that the active recall set contains an active trace no. 1.
CALC:MARK ON
Create marker no. 1 and set it to the center of the sweep range.
CALC:MARK:DELT ON
Create a reference marker at the center of the sweep range and
set marker 1 to delta mode.
Manual operation: See "Delta Mode" on page 393
CALCulate<Chn>:MARKer<Mk>:EXCursion <Value>
CALCulate<Chn>:MARKer<Mk>:REFerence:EXCursion <TargetSearchVal>
Defines a marker-specific minimum excursion value for peak searches.
Use CALCulate<Chn>:MARKer<Mk>:EXCursion:STATe or CALCulate<Chn>:
MARKer<Mk>:REFerence:EXCursion:STATeto activate it.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number (ignored for reference markers)
Parameters:
<Value> Minimum peak excursion
The unit is derived from the active trace format and cannot be
modified. Changing the trace format resets the excursion to a
format-specific default value.
Manual operation: See "Excursion Settings" on page 401
CALCulate<Chn>:MARKer<Mk>:EXCursion:STATe <Boolean>
CALCulate<Chn>:MARKer<Mk>:REFerence:EXCursion:STATe <Boolean>
Activates or deactivates the marker-specific minimum excursion for peak searches.
Use CALCulate<Chn>:MARKer<Mk>:EXCursion or CALCulate<Chn>:
MARKer<Mk>:REFerence:EXCursion to set the minimum peak excursion.
SCPI command reference