Epson AcuLaser CX11 - Fip-7

EPSON AcuLaser CX11/CX11F Revision B
TROUBLESHOOTING Printer 159
FIP-7
 Panel Message
 Photocondctr Trouble
 Possible parts that caused the error
 Troubleshooting
 Photoconductor Unit  GUIDE CRU ASSY D or ANTENNA
ASSY
 HARNESS-ASSY XERO  PWBA MCU
 LV/HVPS
Step Check Yes No
1
Attachment check of Photoconductor Unit
Re-attach Photoconductor Unit.
Does the error recur when the power is turned
ON?
Go to Step [2]. End of procedure
2
Check after replacement of Photoconductor
Unit
Replace Photoconductor Unit.
Does the error recur when the power is turned
ON?
Go to Step [3]. End of procedure
3
Check of ANTENNA ASSY
Is ANTENNA ASSY dirty and damaged?
Clean
ANTENNA
ASSY, and then
proceed to step
[4].
Go to Step [5].
4
Does the error recur when the power is
turned ON?
Go to Step [5]. End of procedure
5
Continuity check of HARNESS-ASSY
XERO
Disconnect P/J416 from PWBA MCU.
Do all of the wiring below have normal
continuity?
J416-4 ↔ J109-2
J416-5 ↔ J109-1
Go to Step [6]. Replace
HARNESS-
ASSY XERO.
6
Check after replacement of GUIDE CRU
ASSY D or ANTENNA ASSY
Replace GUIDE CRU ASSY D or ANTENNA
ASSY. (p.388) or (p.391)
Does the error recur when the power is turned
ON?
Go to Step [7]. End of procedure
7
Power supply check to PWBA MCU
Are the following power voltages being
supplied to PWBA MCU from LV/HVPS?
J410-1 ↔ J410-2: 3. 3 VDC
J410-3 ↔ J410-4: 5 VDC
J410-5/6 ↔ J410-7/8: 24 VDC
Replace PWBA
MCU. (p.432)
Go to Step [8].
8
Continuity check of HARNESS ASSY MAIN
Disconnect P/J410 from PWBA MCU and P/
J502 from LV/HVPS.
Do all of the wiring below have normal
continuity?
J410-1 ↔ J502-1
J410-2 ↔ J502-2
J410-3 ↔ J502-3
J410-4 ↔ J502-4
J410-5 ↔ J502-5
J410-6 ↔ J502-6
J410-7 ↔ J502-7
J410-8 ↔ J502-8
Replace LV/
HVPS. (p.435)
Repair broken or
shorted part.
Step Check Yes No