Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F Revision B
DISASSEMBLY AND ASSEMBLY Printer 306
4.2 Printer
4.2.1 SCANNER
REMOVAL
1. Remove the accordion shaped rubber covers (HINGE COVER L, HINGE COVER
R) from the left and right hinge sections.
2. Remove the COVER ASSY LH. (p321)
3. Remove the two screws (silver, with flange, 8 mm) that secure the COVER LEG
LH OUTER to the main unit, and remove the COVER LEG LH OUTER from the
main unit together with the HINGE COVER L.
4. Disconnect the five connectors (CN701 to CN705) on the PWBA ESS.
5. Remove the screw (silver, with flange, 8mm) that secures the WIRE GROUND of
the SCANNER.
6. Release the harnesses of the SCANNER from the clamp.
7. Remove the two screws (silver, with flange, 8 mm) that secure the SPRING SC
FFC to the main unit, and remove the SPRING SC FFC from the main unit.
8. Remove the five screws (silver-with flange-8mm x 4, silver-no flange-8mm x 1)
that secure the SCANNER to the main unit.
9. Lift the SCANNER straight above the main unit to remove the SCANNER from
the main unit.
.
Figure 4-2. Removal of SCANNER
C A U T I O N
Be careful not to damage the cable by getting it stuck or hitting it in/
against the components inside the printer when pulling out the cable
from the printer main unit to remove the scanner.
Leg_03_600RD
CN705 CN704
CN703
CN701
CN702
FERRITE CORE
Black Tape
CN704(12 pin)
CN701(14 pin)
CN702(13 pin)
NOTE
7)
4)
8)
7)
3)
6)-1
6)-1
6)-2
6)-2
2)-1
2)-1
2)-2
5)
HINGE
COVER L
manuals4you.commanuals4you.com

Epson AcuLaser CX11 Specifications

General

Brand	Epson
Model	AcuLaser CX11
Category	All in One Printer
Language	English