EPSON AcuLaser CX11/CX11F Revision B
TROUBLESHOOTING Printer 149
3.4.4.2 List of Service Request
Table 3-11. List of Service Request
Class Panel Messaeg Description See FIP
Engine Related (E)
Service Req E510 ROS Motor Failure
40 (p.208)
PWBA MCU could not receive signals output from SOS Sensor in ROS within the specified time.
Service Req E511 TR0 Failure
39 (p.206)
PWBA MCU could not receive signals output from SENSOR TR-0 (TR0 Sensor) at the specified timing.
Service Req E513 NVRAM Error
38 (p.205)
An error occurred in NVRAM on PWBA MCU.
Service Req E514 PAGE Timeout
37 (p.204)
The PAGEC/PAGE signal was not received within 60sec after transmitting PFA.
Service Req E517 Communication Error Feeder
36 (p.203)
A communication error occurred between PWBA MCU and Feeder.
Service Req E520 BTR 2 Advance Error
47 (p.217)
The 2nd BTR Retract Sensor does not turn ON within the specified time.
Service Req E521 BTR 2 Error
46 (p.216)
The input of 2nd BTR Retract Sensor does not change when 2nd BTR is initialized.
Service Req E524 Low Density
44 (p.213)
The output value of SENSOR ASSY ADC (ADC Sensor) is below the specified value.
Service Req E525 High Density
43 (p.211)
The output value of SENSOR ASSY ADC (ADC Sensor) exceeds the specified value.
Service Req E526 ADC Contamination
42 (p.210)
SENSOR ASSY ADC (ADC Sensor) error
To Next Page
Loading...
Need help?
General
