EPSON AcuLaser CX11/CX11F Revision B
MAINTENANCE On-site Service 547
6.2 On-site Service
This section describes about on-site servicing procedures.To prevent possible accidents
during servicing, strictly observe the warnings and cautions given in this section and
Section 6.1.Never perform dangerous operations.
ON-SITE SERVICING FLOWCHART
Figure 6-1. On-site Servicing Flowchart
C A U T I O N
îš„ When it is necessary to transport the main unit, use the special
packing material, pallet, etc.
îš„ Be sure to bring back trash created during the work and old
parts or consumables that are replaced, and not to leave them
on the site.
îš„ Before starting your work, spread a sheet of cloth or paper
over the working place to prevent the site from getting dirt with
spilt toner.
Which is the Purpose of Visit?
Maintenance
Repair
Preventive maintenance
Perform troubleshooting according
to the procedure given in Chapter 3.
What to Do Last
1. Check the printer appearance.
2. Train the user as necessary
Cleaning
Image Quality Check
Replacement of regular replacement
parts and main after-sales service parts
General operation checks
What to Do First
1. Ask the user about the printer conditions.
2. Ensure safety.
3. Grasp the printer conditions from the status sheet.
4. Grasp how the printer has been used from the engine status sheet.
Trouble Repeatability Check
To Next Page
Loading...
Need help?
General
