Mechanical Components
When servicing any driving assembly (e.g., gears), first turn the power off and unplug
the power cord. Then manually rotate the assembly.
High Temperature Assembly
When working with hot parts (FUSER etc.) make sure to turn the power off, unplug the
power cable, and leave the printer until it cools down sufficiently to work on it to
prevent burn injury.
W A R N I N G
Do not touch the driving part (e.g., gears) while the assembly
(printer) is operating.
W A R N I N G
As the inside of the printer is high-temperature state immediately
after the operation, leave it more than 30 minutes before working.
Leg_001_022RA
FUSER Unit
Caution Label
(Refer to “Caution Label About High-temperature Surface”)
manuals4you.commanuals4you.com
To Next Page
Loading...
