EPSON AcuLaser CX11/CX11F Revision B
ADJUSTMENT Printer Section 532
5.2 Printer Section
5.2.1 Writing USB ID
AcuLaser CX11/CX11F are equipped with a USB interface as a standard feature. The
PC connected to the product via the USB interface identifies the product by referring to
the USB ID information specific to each product. AS the USB ID information is stored
in the EEPROM on the main board, writing the USB ID on the new main board is
required after replacing the board.
The procedure to write the USB ID is given below.
REQUIRED TOOL
The following shows the name of the program to write the ID, and the operating
environment.
Program
Main Board Initialization Tool
Operating Environment
(OS)
Windows95/OSR2.0 or later, Windows98, Windows Me, Windows 2000/XP
Port
LPT, USB
INSTALLATION METHOD AND BASIC OPERATION
1. Copy all the “Main Board Initialization Tool” files in a folder onto a computer.
2. Double-click on the [ ] icon to start up the program and select AcuLaser CX11
or AcuLaser CX11F in the “Select Model”.
3. Select the port used to connect the printer at the [Interface].
Figure 5-1. Basic Operation
C A U T I O N
All the files of “Main Board Initialization Tool” should be copied in
one folder.
C H E C K
P O I N T
If you select “Auto”, connected products are detected and
communication with the first detected one start automatically.
When connecting with 2 or more products, specify the target port to
avoid unexpected connection since the auto detection varies
depending on the connection state.
manuals4you.commanuals4you.com
To Next Page
Loading...
Need help?
General
