Epson AcuLaser CX11 - Page 489

EPSON AcuLaser CX11/CX11F Revision B
DISASSEMBLY AND ASSEMBLY Scanner Section 491
REINSTALLATION
1. Put the FFC CR through the ferrite core of the CORE ASSY, and bundle the FFC
CR with a piece of tape.
2. Pull out the FFC CR outward through the hole of the IR BASE A ASSY, and
secure the FFC CR to the IR BASE ASSY with the sponge.
3. Draw the FFC CR under the PLATE-HW, and secure the FFC CR to the IR BASE
A ASSY with two-sided tapes aligning the FFC CR with the reference line on the
IR BASE A ASSY.
4. Hitch the hook of the PLATE HARNESS to the IR PLATE FFC, and secure the
PLATE HARNESS to the IR BASE A ASSY with the screw (M3 x 8 mm, P-type,
B-head).
5. Secure the PLATE HARNESS 2 to the IR BASE A ASSY with the two screws
(M3 x 8 mm, P-type, B-head) matching the positioning holes of the PLATE
HARNESS 2 with the guide pins of the IR BASE A ASSY.
6. Connect the FFC BOARD to the connector on the PCB ASSY.
7. Install the MOTOR ASSY. (p487)
8. Attach the CCD MODULE ASSY. (p485)
9. Attach the IR COVER A ASSY. (p482)
10. Attach the ADF Unit. (p481)
11. Install the Scanner. (p306)
Figure 4-169. Reinstallation of FFC CR (1)
Figure 4-170. Reinstallation of FFC CR (2)
C H E C K
P O I N T
Attach the sponge, which secures the FFC CR, to the IR BASE A
ASSY with a two-sided tape.
Sponge
PLATE-HW
Ferrite Core
FFC CR
Two-sided Tapes Attaching Positions Reference Line for attaching the FFC CR
PLATE HARNESS
PLATE HARNESS2
IR PLATE FFC
Hook of the PLATE HARNESS
Positioning Holes and Guide Pins