1018 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
33 :WGEN Commands
:WGEN:MODulation:FSKey:RATE
(see page 1138)
Command Syntax
:WGEN:MODulation:FSKey:RATE <rate>
<rate> ::= FSK modulation rate in Hz in NR3 format
The :WGEN:MODulation:FSKey:RATE command specifies the rate at which
the output frequency "shifts".
The FSK rate specifies a digital square wave modulating signal.
Query Syntax
:WGEN:MODulation:FSKey:RATE?
The :WGEN:MODulation:FSKey:RATE? query returns the FSK rate setting.
Return Format
<rate><NL>
<rate> ::= FSK modulation rate in Hz in NR3 format
See Also • ":WGEN:MODulation:AM:DEPTh" on page 1013
• ":WGEN:MODulation:AM:FREQuency" on page 1014
• ":WGEN:MODulation:FM:DEViation" on page 1015
• ":WGEN:MODulation:FM:FREQuency" on page 1016
• ":WGEN:MODulation:FSKey:FREQuency" on page 1017
• ":WGEN:MODulation:FUNCtion" on page 1019
• ":WGEN:MODulation:FUNCtion:RAMP:SYMMetry" on page 1020
• ":WGEN:MODulation:STATe" on page 1022
• ":WGEN:MODulation:TYPE" on page 1023
To Next Page
Loading...
