Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

934 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

31 :TRIGger Commands

:TRIGger:SHOLd:SOURce:CLOCk

(see page 1138)

Command Syntax

:TRIGger:SHOLd:SOURce:CLOCk <source>

<source> ::= {CHANnel<n> | DIGital<d>}

<n> ::= 1 to (# analog channels) in NR1 format

<d> ::= 0 to (# digital channels - 1) in NR1 format

The :TRIGger:SHOLd:SOURce:CLOCk command selects the input channel

probing the clock signal.

Query Syntax

:TRIGger:SHOLd:SOURce:CLOCk?

The :TRIGger:SHOLd:SOURce:CLOCk? query returns the currently set clock

signal source.

Return Format

<source> ::= {CHAN<n> | DIG<d>}

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:MODE" on page 886

• ":TRIGger:SHOLd:SLOPe" on page 933

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series