Agilent Technologies InfiniiVision 3000 X-Series

What's New 1
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 37
What's New in Version 2.00
New features in version 2.00 of the InfiniiVision 3000 X- Series oscilloscope
software are:
• Support for the DSOX3WAVEGEN waveform generator's new arbitrary
waveform type.
• Support for the new DSOX3VID extended Video triggering license.
• Support for the new DSOX3AERO MIL- STD- 1553 and ARINC 429
triggering and serial decode license.
• Support for the new DSOX3FLEX FlexRay triggering and serial decode
license.
• Support for the new DSOX3PWR power measurements and analysis
license.
• Support for the new DSOX3ADVMATH advanced math measurements
license.
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command Description
:FUNCtion:BUS:CLOCk (see page 328) Selects the clock signal source for the Chart
Logic Bus State operation. Available with the
DSOX3ADVMATH advanced math license.
:FUNCtion:BUS:SLOPe (see page 329) Specifies the clock signal edge for the Chart
Logic Bus State operation. Available with the
DSOX3ADVMATH advanced math license.
:FUNCtion:BUS:YINCrement (see page 330) Specifies the value associated with each
increment in Chart Logic Bus data. Available
with the DSOX3ADVMATH advanced math
license.
:FUNCtion:BUS:YORigin (see page 331) Specifies the value associated with Chart Logic
Bus data equal to zero. Available with the
DSOX3ADVMATH advanced math license.
:FUNCtion:BUS:YUNits (see page 332) Specifies the vertical units for the Chart Logic
Bus operations. Available with the
DSOX3ADVMATH advanced math license.
:FUNCtion:FREQuency:HIGHpass (see
page 338)
Sets the high-pass filter's -3 dB cutoff
frequency. Available with the
DSOX3ADVMATH advanced math license.
:FUNCtion:FREQuency:LOWPass (see
page 339)
Sets the low-pass filter's -3 dB cutoff
frequency. Available with the
DSOX3ADVMATH advanced math license.