Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

940 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

31 :TRIGger Commands

:TRIGger:TRANsition:SLOPe

(see page 1138)

Command Syntax

:TRIGger:TRANsition:SLOPe <slope>

<slope> ::= {NEGative | POSitive}

The :TRIGger:TRANsition:SLOPe command specifies a POSitive rising edge

or a NEGative falling edge.

Query Syntax

:TRIGger:TRANsition:SLOPe?

The :TRIGger:TRANsition:SLOPe? query returns the current rise/fall time

trigger slope setting.

Return Format

<slope> ::= {NEG | POS}

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:MODE" on page 886

• ":TRIGger:TRANsition:SOURce" on page 941

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series