Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:MEASure Power Commands 21
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 487
:MEASure:RIPPle
(see page 1138)
Command Syntax
:MEASure:RIPPle [<source>]
<source> ::= {CHANnel<n>| FUNCtion | MATH | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<r> ::= 1-2 in NR1 format
The :MEASure:RIPPle command installs an output ripple measurement on
screen.
The <source> parameter is the channel probing the output voltage. This
source can also be specified by the :MEASure:SOURce command.
Output ripple is: Vmax - Vmin.
Query Syntax
:MEASure:RIPPle? [<source>]
The :MEASure:RIPPle query returns the measured output ripple.
Return Format
<return_value><NL>
<return_value> ::= the output ripple value in NR3 format
See Also • ":MEASure:SOURce" on page 444
• ":POWer:RIPPle:APPLy" on page 563

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English