Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

880 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

31 :TRIGger Commands

:TRIGger:FORCe

(see page 1138)

Command Syntax

:TRIGger:FORCe

The :TRIGger:FORCe command causes an acquisition to be captured even

though the trigger condition has not been met. This command is equivalent

to the front panel [Force Trigger] key.

See Also • "Introduction to :TRIGger Commands" on page 877

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series