Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:MTESt Commands 22
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 513
:MTESt:RMODe:SIGMa
(see page 1138)
Command Syntax
:MTESt:RMODe:SIGMa <level>
<level> ::= from 0.1 to 9.3 in NR3 format
When the :MTESt:RMODe command is set to SIGMa, the
:MTESt:RMODe:SIGMa command sets the test sigma level to which a mask
test runs. Test sigma is the best achievable process sigma, assuming no
failures. (Process sigma is calculated using the number of failures per
test.) The test sigma level indirectly specifies the number of waveforms
that must be tested (in order to reach the sigma level).
Query Syntax
:MTESt:RMODe:SIGMa?
The :MTESt:RMODe:SIGMa? query returns the current Sigma level setting.
Return Format
<level><NL>
<level> ::= from 0.1 to 9.3 in NR3 format
See Also • "Introduction to :MTESt Commands" on page 491
• ":MTESt:RMODe" on page 508
Example Code • "Example Code" on page 491

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English