Agilent Technologies InfiniiVision 3000 X-Series - Sbus<N>:Spi:source:clock

744 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:SPI:SOURce:CLOCk
(see page 1138)
Command Syntax
:SBUS<n>:SPI:SOURce:CLOCk <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:SPI:SOURce:CLOCk command sets the source for the SPI
serial clock.
Query Syntax
:SBUS<n>:SPI:SOURce:CLOCk?
The :SBUS<n>:SPI:SOURce:CLOCk? query returns the current source for
the SPI serial clock.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:SPI:CLOCk:SLOPe" on page 741
• ":SBUS<n>:SPI:CLOCk:TIMeout" on page 742
• ":SBUS<n>:SPI:SOURce:FRAMe" on page 745
• ":SBUS<n>:SPI:SOURce:MOSI" on page 747
• ":SBUS<n>:SPI:SOURce:MISO" on page 746
• ":SBUS<n>:SPI:SOURce:DATA" on page 1092