Agilent Technologies InfiniiVision 3000 X-Series

Root (:) Commands 6
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 215
:PRINt
(see page 1138)
Command Syntax
:PRINt [<options>]
<options> ::= [<print option>][,..,<print option>]
<print option> ::= {COLor | GRAYscale | PRINter0 | PRINter1 | BMP8bit
| BMP | PNG | NOFactors | FACTors}
The <print option> parameter may be repeated up to 5 times.
The PRINt command formats the output according to the currently
selected format (device). If an option is not specified, the value selected in
the Print Config menu is used.
See Also • "Introduction to Root (:) Commands" on page 190
• "Introduction to :HARDcopy Commands" on page 358
• ":HARDcopy:FACTors" on page 361
• ":HARDcopy:GRAYscale" on page 1063
• ":DISPlay:DATA" on page 304