Agilent Technologies InfiniiVision 3000 X-Series

:SYSTem Commands 29
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 861
:SYSTem:PROTection:LOCK
(see page 1138)
Command Syntax
:SYSTem:PROTection:LOCK <value>
<value> ::= {{1 | ON} | {0 | OFF}}
The :SYSTem:PROTection:LOCK command disables the fifty ohm impedance
setting for all analog channels.
Query Syntax
:SYSTem:PROTection:LOCK?
The :SYSTem:PROTection:LOCK? query returns the analog channel
protection lock status.
Return Format
<value><NL>
<value> ::= {1 | 0}
See Also • "Introduction to :SYSTem Commands" on page 852