Agilent Technologies InfiniiVision 3000 X-Series

644 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:A429:SPEed
(see page 1138)
Command Syntax
:SBUS<n>:A429:SPEed <speed>
<speed> ::= {LOW | HIGH}
The :SBUS<n>:A429:SPEed command specifies the signal speed:
• LOW — 12.5 kb/s.
• HIGH — 100 kb/s.
Query Syntax
:SBUS<n>:A429:SPEed?
The :SBUS<n>:A429:SPEed? query returns the current ARINC 429 signal
speed setting.
Return Format
<speed><NL>
<speed> ::= {LOW | HIGH}
Errors • "- 241, Hardware missing" on page 1099
See Also • "Introduction to :SBUS<n> Commands" on page 629
• ":SBUS<n>:MODE" on page 633
• ":SBUS<n>:A429:SIGNal" on page 642
• ":SBUS<n>:A429:FORMat" on page 641
• ":SBUS<n>:A429:SOURce" on page 643