Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

736 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

27 :SBUS<n> Commands

:SBUS<n>:M1553:TRIGger:RTA

(see page 1138)

Command Syntax

:SBUS<n>:M1553:TRIGger:RTA <value>

<value> ::= 5-bit integer in decimal, <nondecimal>, or

<string> from 0-31

<nondecimal> ::= #Hnn where n ::= {0,..,9|A,..,F}

<string> ::= "0xnn" where n::= {0,..,9|A,..,F}

The :SBUS<n>:M1553:TRIGger:RTA command sets the Remote Terminal

Address (RTA) to trigger on when the trigger type has been set to RTA or

RTA11 (using the :SBUS<n>:M1553:TRIGger:TYPE command).

To set the RTA value to don't cares (0xXX), set the value to - 1.

Query Syntax

:SBUS<n>:M1553:TRIGger:RTA?

The :SBUS<n>:M1553:TRIGger:RTA? query returns the RTA value.

Return Format

<value><NL> in decimal format

See Also • "Introduction to :TRIGger Commands" on page 877

• ":SBUS<n>:M1553:TRIGger:TYPE" on page 737

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series