450 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
20 :MEASure Commands
:MEASure:STATistics:RESet
(see page 1138)
Command Syntax
:MEASure:STATistics:RESet
This command resets the measurement statistics, zeroing the counts.
Note that the measurement (statistics) configuration is not deleted.
See Also • "Introduction to :MEASure Commands" on page 406
• ":MEASure:STATistics" on page 446
• ":MEASure:STATistics:DISPlay" on page 447
• ":MEASure:RESults" on page 438
• ":MEASure:STATistics:INCRement" on page 448
Example Code • "Example Code" on page 438
To Next Page
Loading...
