Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

:TRIGger Commands 31

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 899

:TRIGger:EBURst:SLOPe

(see page 1138)

Command Syntax

:TRIGger:EBURst:SLOPe <slope>

<slope> ::= {NEGative | POSitive}

The :TRIGger:EBURst:SLOPe command specifies whether the rising edge

(POSitive) or falling edge (NEGative) of the Nth edge in a burst will

generate a trigger.

Query Syntax

:TRIGger:EBURst:SLOPe?

The :TRIGger:EBURst:SLOPe? query returns the current Nth edge in a

burst slope.

Return Format

<slope> ::= {NEG | POS}

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:EBURst:IDLE" on page 898

• ":TRIGger:EBURst:COUNt" on page 897

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series