Agilent Technologies InfiniiVision 3000 X-Series

582 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:SIGNals:SOURce:VOLTage<i>
(see page 1138)
Command Syntax
:POWer:SIGNals:SOURce:VOLTage<i> <source>
<i> ::= 1, 2 in NR1 format
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :POWer:SIGNals:SOURce:VOLTage<i> command specifies the first, and
perhaps second, voltage source channel to be used in the power analysis.
Query Syntax
:POWer:SIGNals:SOURce:VOLTage<i>?
The :POWer:SIGNals:SOURce:VOLTage<i> query returns the voltage source
channel setting.
Return Format
<source><NL>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
See Also • ":POWer:SIGNals:AUTosetup" on page 564
• ":POWer:SIGNals:CYCLes:HARMonics" on page 565
• ":POWer:SIGNals:CYCLes:QUALity" on page 566
• ":POWer:SIGNals:DURation:EFFiciency" on page 567
• ":POWer:SIGNals:DURation:MODulation" on page 568
• ":POWer:SIGNals:DURation:ONOFf:OFF" on page 569
• ":POWer:SIGNals:DURation:ONOFf:ON" on page 570
• ":POWer:SIGNals:DURation:RIPPle" on page 571
• ":POWer:SIGNals:DURation:TRANsient" on page 572
• ":POWer:SIGNals:IEXPected" on page 573
• ":POWer:SIGNals:OVERshoot" on page 574
• ":POWer:SIGNals:VMAXimum:INRush" on page 575
• ":POWer:SIGNals:VMAXimum:ONOFf:OFF" on page 576
• ":POWer:SIGNals:VMAXimum:ONOFf:ON" on page 577
• ":POWer:SIGNals:VSTeady:ONOFf:OFF" on page 578
• ":POWer:SIGNals:VSTeady:ONOFf:ON" on page 579
• ":POWer:SIGNals:VSTeady:TRANsient" on page 580
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 581