Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

:SBUS<n> Commands 27

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 773

:SBUS<n>:UART:TRIGger:QUALifier

(see page 1138)

Command Syntax

:SBUS<n>:UART:TRIGger:QUALifier <value>

<value> ::= {EQUal | NOTequal | GREaterthan | LESSthan}

The :SBUS<n>:UART:TRIGger:QUALifier command selects the data qualifier

when :TYPE is set to RDATa, RD1, RD0, RDX, TDATa, TD1, TD0, or TDX

for the trigger when in UART mode.

Query Syntax

:SBUS<n>:UART:TRIGger:QUALifier?

The :SBUS<n>:UART:TRIGger:QUALifier? query returns the current UART

trigger qualifier.

Return Format

<value> ::= {EQU | NOT | GRE | LESS}

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:MODE" on page 886

• ":SBUS<n>:UART:TRIGger:TYPE" on page 774

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series