Agilent Technologies InfiniiVision 3000 X-Series - Trigger:delay:trigger:slope

894 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
31 :TRIGger Commands
:TRIGger:DELay:TRIGger:SLOPe
(see page 1138)
Command Syntax
:TRIGger:DELay:TRIGger:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:DELay:TRIGger:SLOPe command specifies rising (POSitive) or
falling (NEGative) for the trigger edge in the Edge Then Edge triggger.
Query Syntax
:TRIGger:DELay:TRIGger:SLOPe?
The :TRIGger:DELay:TRIGger:SLOPe? query returns the current trigger edge
slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:DELay:TRIGger:SOURce" on page 895
• ":TRIGger:DELay:TDELay:TIME" on page 892
• ":TRIGger:DELay:TRIGger:COUNt" on page 893